The design of your blasting equipment can have a major influence on the surface preparation condition obtained, and on the efficiency of the blasting process. The correct blast pressure, abrasive supply, nozzle type, and blasting technique must be used to ensure the steel surface meets the desired s

Did you know? Inferior abrasives may lead to dust pollution.This healthy demand is a result of growing requirements for ultra high pressure cutting for steel applications, with the advantages appealing to wide global industry sector.The main advantages of waterjet cutting for steel applications:- No

The type of garnet abrasive used by your waterjet machine also plays a vital role in achieving operational cost efficiencies, optimal cutting speed and cutting edge quality.At SEPPE we’ve spent a lot of time globally understanding how our products perform and compare that with other abrasives and ho

Garnet as a natural abrasive can be used for waterjet cutting because of its high hardness, high cutting speed.

SEPPE garnet sandblasting abrasive has high hardness, long lifetime, high efficiency, low consumption and high recycling rate.In the process of surface preparation, SEPPE garnet is blasted on to the surface of the steel with the use of high pressure compressed air. This process is called sand blasti

Waterjet cutting, that is, high-pressure water jet cutting technology, starts from the pressure pump, passes through the high-pressure pipe, and then shoots out from the cutting nozzle. Under the control of the computer, the workpiece can be arbitrarily carved, which is less affected by the material

If you’ve ever had to refinish iron furniture, then you know just how difficult a task this can be. In addition to the work needed to strip your furniture of its old paint, there is the possibility that the new paint will run or that an imperfection you missed will ruin the entire project. Fortunate

SEPPE Garnet is one of the very best abrasive options for many blast shop operations. High speed, very low dust and the lowest consumption rate compared to conventional abrasives highlight the advantageous of SEPPE Garnet. Some of the other benefits are listed below.1.Extremely hard (7.5-8 MOH Hard

Wet blasting does not impregnate media into the surface and creates no heat which eliminates part warping.Dry sandblasting leaves a much duller and textured finish compared to the wet blasting.It is also important to mention that since water is added there is no harmful dust with no dust collector

Garnet sand is a green and environment-friendly abrasive because it does not contain free silicon and will not cause occupational harm to the body of sandblasting workers. Most importantly, due to the high hardness of garnet sand, if there is a good recovery system, it can be reused for many times.