When high-quality garnet abrasives are used for waterjet cutting, the cutting speed is faster and the cross section is smoother. If the quality of garnet abrasive is not good enough, it actually increases the cost in some aspects.The high-quality garnet abrasive will be washed many times, then scree

One of the reasons for the sharpness of water cutting is high-pressure water and the other is abrasive. The water first passes through the purified water supply system, where the water is pumped into low-pressure water by means of a pump. Then it is pressurized by the piston into the supercharger, a

Aluminum oxide or silicon carbide? We will help you make the right decision for your next sanding project.

Fluorite, also known as fluorspar, is the main source of fluorine in industry, and is one of the 20 important nonmetallic mineral raw materials in the world. It is widely used in metallurgy, aluminum smelting, glass, ceramics, cement, chemical industry. The pure, colorless and transparent fluorite c

waterjet Abrasives make up one of the most important components in the waterjet cutting process.

White fused alumina is made of high-quality bauxite, which is smelted in an arc at a high temperature of more than 2000 degrees and then cooled. It is suitable for the manufacture of ceramics, resin bonded abrasives, grinding, polishing, sandblasting, precision casting, etc. It can also be used to m

Fluorspar powder(Fluorite powder) can be divided into dry powder and wet powder.Fluorspar powder used in chemical industry generally requires calcium fluoride content of more than 97%, so most of fluorspar powder is prepared by flotation. By adding various chemical agents, calcium fluoride can be ef

River garnet through the impact of water, is a natural abrasive. Hardness, and more smooth, less damage to materials and machines.Compared with rock garnet, river garnet sand can keep the cutting surface smooth and flat. Because river sand is formed after a long time of impact, so its grain edge sur

SEPPE calcined bauxiteCalcined bauxite is one of the principal ore of aluminum. Calcined bauxite is obtained by calcining (heating) superior grade bauxite at high temperature (from 850℃ to 1600℃). This removes moisture thereby increasing the alumina content. Compared to an alumina content of about 5

SEPPE Proppants is a professional manufacturer of ceramic proppant such as Ultra lightweight, light weight proppant ( LWP ), Intermediate strength proppant ( ISP ) , Ultra-High density sintered bauxite proppant ( HSP ) that are used in the exploitation of hydraulic fracturing in gas&oil fields.SEPPE